Cold Jet AERO 2 PCS 60, Operator'S Manual

Page: 21 / 32

34 35
Advanced Settings
The advanced settings screen is for setting up preferences for the PCS 60 such as units of measure,
thumper time and more. If dry ice begins clumping in the hopper the thumper and ramrod
frequency and time can be increased to help the flow of dry ice while blasting.
Figure 11: Advanced Settings Screen
1. To access the Advanced Settings screen:
a. From the Home screen, use the rotary encoder dial to select settings then advanced
settings.
2. To change the units of measurement (A):
a. Using the rotary encoder dial, navigate to units and press to select.
b. Toggle between US standard (LB | PSI | °F) or metric (KG | BAR | °C) and press to
select.
3. To change the thumper and ramrod settings (B, C, D, and E):
a. For thumper and ramrod time (B), use the rotary encoder dial to adjust the timing in
between the thumper/ramrods (in seconds).
b. The SureFlow hopper on/off (C) operates based on the vibrator on/off values when
dry ice is detected at the second mid hopper level sensor.
c. For vibrator on (D), adjust the number of seconds the hopper will vibrate. For vibrator
off (E), adjust the number of minutes between vibrations.
Emergency Stop
The emergency stop button is used in the event that the PCS 60 must be shut down immediately. If
any event occurs that could cause harm to personnel or equipment then use the emergency stop to
shut down the PCS 60.The Emergency stop button is a push pull button. Once pushed, the button
must be rotated clockwise to reset. Then reset the PCS 60 on the screen.
CAUTION Do not use the emergency stop button to shut down the PCS 60 for anything
other than an emergency
Reset Screen
The reset screen appears if the emergency stop has been activated or the safeguard grate has
been removed. When the reset screen appears, first correct the issue. If the emergency stop has
been activated — reset the emergency stop by rotating clockwise. If the safeguard grate has been
removed, re-install it. Use the rotary encoder dial to press the button indicated by the animation.
This will reset the machine and the splash screen, then the home screen will boot up. The PCS 60
logic will validate that the issue has been satisfied and calibrate. After calibration the machine will
return to its last mode of operation and the settings will return to the settings used prior to shut
down.