Modular Variable Optical Attenuator
|
VOA
Blade
Coherent Solutions
|
VOA
Blade (V1.4)
8
7 Installing a VOABlade Expansion Module
W
ARNING
DO NOT
attempt to remove or adjust any component of the MTP1000 while the
power is on. Make sure you follow the correct procedures below and power down
the MTP1000 first.
C
AUTION
Do not remove the VOABlade from the antistatic packaging until instructed
during the following installation procedure.
The VOABlade is sensitive to ESD. Please be sure to wear a grounded wrist
strap at all times when handling the VOABlade module to prevent such
damage.
Take care not to handle the connector on the VOABlade module once they are
exposed as this may leave corrosive residue which can damage the connector.
Note
: You will need a Phillips screwdriver to both unfasten the blanking module and secure the new VOABlade
module in place.
Power down the MTP1000
1.
Press the
Power On/Off
switch. The switch will
no longer be illuminated indicating that the
instrument is off.
Remove the blanking module
2.
To remove the
blanking module
of the desired
slot, loosen the screw underneath the
release
latch
. Do not attempt to
remove the screw completely as they are
designed to stay inside the
release latch
.
Figure 4 - Turn Off Power
Figure 5 - Unfasten screw under Release Latch
Summary of Contents for MTP-1000
Page 1: ......
Page 49: ...V1 2 ...
