Connect the Ethernet Cable
1. Connect the Ethernet cable M12 connector to the vision sensor Ethernet connector.
2. Connect the Ethernet cable RJ-45 connector to a switch/router or PC, as applicable. For PoE models, connect the
Ethernet cable to a PoE switch port or other PoE sources.
Connect the Breakout Cable (Optional for PoE Models)
CAUTION
:
If you purchased an In-Sight 2000 vision sensor with PoE (Power over Ethernet) model, the Breakout
cable is used only to connect the I/O or serial wires to a PLC or a serial device. Do not connect the Breakout cable
to a 24VDC power supply.
Note
: You can clip unused wires short or use a tie made of non-conductive material to tie them back. Keep bare
wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Optionally, connect the I/O or serial wires to an appropriate device (for example, a PLC or a serial device). For
more information, refer to
.
3. For non-PoE models, attach the Breakout cable +24VDC (red wire) and GROUND (black wire) to the
corresponding terminals on the power supply.
CAUTION
:
Never connect voltages other than 24VDC. Always observe the polarity shown.
38
Installation
