Mounting and Connecting the Verifier
CAUTION
:
Make sure that the Ethernet cable is grounded at the far end.
Whatever this cable is plugged into (usually a switch or router) should have a
grounded Ethernet connector. Use a digital voltmeter to validate the
grounding. If the far end device is not grounded, add a ground wire in
compliance with local electrical codes.
CAUTION
:
To reduce emissions, connect the far end of the Breakout cable
shield to frame ground.
Perform the following steps:
1.
Mount the verifier so that the distance from the bottom of the light housing to
the plane of the code is 60 mm.
Tip
: Measure each corner of the light housing to 60 mm (+/- 3 mm).
2.
Connect the Ethernet cable to a computer or a network switch.
3.
Connect the breakout cable to a 24 V power supply.
For information on the cable pinout and wire colors, see section
Connections, Optics,
and Lighting
in the
DataMan 475 Verifier Reference Manual
.
Note
:
l
Cables are sold separately.
l
If a standard component is missing or damaged, immediately contact
your Cognex Authorized Service Provider (ASP) or Cognex
Technical Support.
9
