Precautions
To reduce the risk of injury or equipment damage, observe the following precautions
when you install the Cognex product:
l
This device requires the use of an LPS or NEC class 2 power supply.
l
Do not connect or disconnect this device from the I/O module or 15-pin USB
adapter cable when the I/O module or adapter cable is connected to a PC.
l
Route cables and wires away from high-current wiring or high-voltage
power sources to reduce the risk of damage or malfunction from the
following causes: over-voltage, line noise, electrostatic discharge (ESD),
power surges, or other irregularities in the power supply.
l
Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authority to operate the
equipment.
l
Ensure that the cable bend radius begins at least six inches from the
connector. Cable shielding can be degraded or cables can be damaged or
wear out faster if a service loop or bend radius is tighter than 10X the cable
diameter.
l
This device should be used in accordance with the instructions in this
manual.
l
All specifications are for reference purposes only and can change without
notice.
Product Overview
2
