1.
Verify that the 24VDC power supply is unplugged and not receiving power.
2.
Connect a cable with RS-232 or USB and flying leads to the cable that is
attached to the DataMan device.
3.
Attach the Breakout cable's +24VDC and GROUND to the corresponding
terminals on the power supply.
CAUTION
:
Never connect voltages other than 24VDC. Always
observe the polarity shown.
4.
Restore power to the 24VDC power supply and turn it on if necessary.
Install Software and Documentation and
Connect the Reader
Follow the steps below to connect your reader to power and network:
1.
Connect the I/O+RS232+24V cable to the cable attached to your reader.
2.
Connect the cable to a 24V power supply.
To configure a DataMan 150 reader, the DataMan Setup Tool software must be
installed on a networked PC. The DataMan Setup Tool is available from the
DataMan support site:
http://www.cognex.com/support/dataman
1.
After installing the software, connect the DataMan 150 Series reader to
your PC.
2.
Launch the DataMan Setup Tool and click
Refresh
.
3.
Select your DataMan 150 reader from the list and click
Connect
.
DataMan 150 Specifications
14
