Coemar Softlite LED RGBW, Instruction Manual, Page: 26 / 32

26
Codice errore Descrizione
DTER
[Data Error]
Data error
Initial data loading has failed the projector loaded the default
data settings: restart the fixture again, and if the error persists
contact the
Coemar assistance center.
ADER
[Address Error]
Address error
The projector does not receive all channels of DMX needs to
function properly. Check the DMX address indicated on the
display and the number of channels generated by the mixer
control. We recall in this connection that some controllers do
not generate all the 512 channels.
noal
No Allarm
The projector self-diagnostic routine didn’t find any issue.
LEd
[LED Error]
LED error
Auto diagnostic routine found that the LED module may
be damaged, contact
Coemar assistance for the module
replacement.
IMPORTANT: To ensure the sensor is giving correct readings,
set the LED to the maximum light output level.
9.7
Error messages
If a malfunction occurs, Softlite Led RGBW has a self-diagnostic system that will show the
error message on the display. The following table will explain in detail the most common
errors. If, despite of suggested intervention, the problem persists, call the
Coemar Service
Center.
9.6
Special functions of the fixture
Storing the DMX signal
If you want to use the fixture without an active DMX console it is possible to store the DMX
settings in two ways:
• Through the
TEST
menu;
• Unconnecting the DMX signal when the fixture is on. When the signal is unconnected
the fixtures stores the signal;
Automatic fan standby
To decrease the noise and the power consumption, the cooling fan turns off after
10 minutes of fixture inactivity.