6
4.1. Mechanical installation
Due to its
IP44
protection rating, the
Panorama Power MK2
may be installed in both covered and weather-exposed locations. To
ensure the protection rating is maintained, there are various installation restrictions with regard to position and tilt which must be adhe-
red to as shown below:
Permanent and temporary installation
So that it may be utilised in a variety of positions, the
Panorama Power MK2
is fitted with four rubber feet on its base.
For more permanent and robust installations, you may remove the four feet and, utilise the four holes corresponding to those marked
“A”
in the following diagram.
When hanging the unit, we recommend the use of the optional support accessory (
cod. 9821
) to which clamps may be attached, as
indicated at
“B”
in the diagram below. The support accessory allows the unit to be rotated through 360°.
Do not install the projector in a location where it may be interfered with by people who are not familiar with the instructions contained
in this manual.
ATTENTION!!
• Always ensure that the suspending structure and any hanging devices (clamps, bolts, etc) are rated suitably for the
weight of the projector.
• Incorrect installation of the projector may cause substantial damage to the projector and will immediately void the
fixture’s warrant.
A
B
cod. 9821
333mm
13.11”
460mm
18.11”
13m
m
0.51”
90mm
3.67”
360mm
14.17”
279mm
10.98”
15
°
Max
15
°
Max
15
°
Max
15
°
Max
15
°
Max
15
°
Max
15
°
Max
15
°
Max
OK
NO
NO
OK
4. Installation
English
