English
31
14. Frequently asked questions
Question
Possible cause
Suggested solution
The projector is completely still.
-
Projector not powered up:
The circuit breaker is switched off.
The protection fuse is blown.
Check that the mains power cable is
connected to power.
Set the circuit breaker to ON.
Disconnect the projector and replace the fuse.
The projector resets correctly, but either does
not respond, or responds incorrectly, to DMX
signal.
Incorrect signal connection.
Incorrect DMX address.
Inspect the signal cable, rectify any incorrect
wiring, repair or replace any damaged cables
or connectors.
Check the DMX address.
The lamp functions intermittently or does not
turn on at all.
The projector is too hot.
Let the fixture cool down.
Check that the air vents above the cooling
fans are not obstructed and that the fans are
working correctly.
Ensure that the ambient temperature is below
35°C
Projection brightness appears reduced
Lamp may be exhausted or not properly
aligned to optical path.
Replace the lamp if exhausted.
Align the lamp to optical path.
Information on disposal of the equipment
The equipment at the end of its useful life must be disposed of at an appropriate recycling center for
waste electrical and electronic equipment. The treatment and disposal of environmentally friendly, helps
prevent potential negative environmental and health and promote the reuse and / or recycling of
materials making up the equipment. Illegal disposal by the user includes the application of administrative
sanctions provided by law.
