http://www.coef.net - [email protected]
Pag. 7
3 - CONNECTIONS
3.1 - Power supply connections
WARNING:
In order to guarantee the utmost safety, connect the apparatus only to a
properly earthed mains system. The projector is designed to work at the tension and
frequency indicated by the electrical data label on the rear. Before connecting the projector
to the mains, a qualified electrician must check its conformity. Should there be different
electrical characteristics or special steps to be carried out, please contact COEF by
telephone or e-mail [email protected]
Supply the projector by connecting it as indicated in picture.
Power supply:
200-240 V. 50-60 Hz. with voltage and frequency as indicated on the
rear of the projector
Power absorbed:
1500 VA 6.3 A with nominal voltage
S/N
CHECK
S/N
CHECK
S/N
CHECK
PHASE
GROUND
NEUTRAL
3.2 - DMX 512 Connection
Connect the projector and the control unit to a wire in conformity with the EIA RS-485
standards: braided bipolar, shielded, 120 ohm of characteristic impedance, 22-24 AWG,
equipped with Cannon 3 Pin XRL plugs. Respect the DMX 512 signal input and output
according to the panel indications. A terminal pin with 120 ohm resistance (¼ Watt
minimum) must be inserted between the terminals 2 and 3 in the last piece of apparatus.
S/N
CHECK
S/N
CHECK
S/N
CHECK
FROM CONTROL UNIT
