Check local requirements for proper ADA recommended height from finished floor.
Attach template and mark horizontal height line on the edge of the door, both door faces and the door jamb. Mark the holes to
be drilled.
Please note:
When installing on a door that is bevelled, make sure you mark the high side of the door.
Verify backset, and mark a vertical center line from edge of door.
Keeping the drill level and straight, drill the holes in the door face on both sides to increase accuracy and to avoid damage to
the other side of the door.
Please note:
When installing on a door that is bevelled, make sure you mark the high side of the door and drill from the high
side only.
2 MARK LATCHBOLT HOLE
On horizontal height line drill a 25mm (1") diameter hole in centre of door edge.
Insert latch into hole and with a pencil mark around latch faceplate. Remove latch.
Chisel out at 3mm (1/8") rebate inside marked area to allow the latch face to fit flush with door.
Install the latch with the two woods screws, with the bevel towards the door frame.
3 INSTALLING THE STRIKE PLATE
Note: The plunger beside the latchbolt deadlocks it, to
protect against manipulation or 'shimming'.
The strike plate
must be accurately installed so that the plunger
CANNOT
enter
the aperture when the door is closed, even if it is slammed
shut.
Postion the strike plate on the door frame so that is lines up
with the flat of the latchbolt, and
NOT
the plunger. Mark the
positions of the mounting screws, and draw around the
aperture of the strike plate. Chisel out the aperture 15mm (3/4")
deep to receive the latchbolt. Install the strike plate to the
surface of the frame using only the top mounting screw. Gently
close the door and check that the latchbolt enters the aperture
easily, and is held without too much 'play'. When satisfied,
draw around the outline of the strike plate, remove it and cut a
rebate to enable the faceplate to lie flush with the surface.
Re-install the strike plate using both screws.
4 INSTALLING THE FRONT PLATE
Position the code side of the lock onto door.
Note: Locks are supplied right handed. To reverse lock hand, see below - Method of changing lock hand.
Make sure latch retractor engages with the tail of the latch.
Pass power cables through upper hole and latch retractor cable through lower hole.
Note: Make sure cables are not trapped.
5 INSTALL INNER ROSE MOUNTING PLATE
Codelocks - CL6010 Lock Installation
http://www.codelocks.co.uk/Locks-Technical-Support/CL6010-Lock-Ins...
2 of 5
21/11/2011 11:44