C005905_04_CR1000_User_Manual
4.0 - Using a CR1000 Out of a Universal Stand
5.0 - Using a CR1000 in a Universal Stand
Revision 3 Hardware
of the CR1000 has a stand detection feature. By default, when the
CR1000 is placed in the stand, the reader will enter into motion detection mode. When
in this mode, simply place a bar code in the scan field to activate the reader. The CR1000
will beep and flash a green LED to indicate a ‘good read’ has occurred.
When the CR1000 is removed from the stand, the reader switches to manual mode and
the button must be pressed to read a bar code (refer to Section 4.0).
Revisions 1 and 2 Hardware
of the CR1000 do not have a
stand detection feature
to enable
motion detection reading when the CR1000 is in a stand. To configure
these hardware revisions for motion detection scanning, please refer to the CR1000
Configuration Guide, located at www.codecorp.com/files.php and scan the appropriate
code.
2
See Section 10.0 to learn how to determine your CR1000
hardware revision number.
Press and hold the button on the top of the CR1000, the two blue bars emitting from the
reader are used for targeting. Center the blue bars in the middle of a bar code. The optimal
reading distance from reader to bar code is approximately 4.0” (10 cm).
Once the reader is at the optimal distance, the reader will read the bar code. The CR1000 will
beep and flash a green LED to indicate a ‘good read’ has occurred.
To modify any default settings, download the CR1000 Configuration Guide at
www.codecorp.com/files.php and scan the appropriate code.
