Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK icon button
on the remote control. The system will sound twice and the parking lights will flash
twice, indicating the system is armed. The doors will also lock at this time (if
equipped and connected). The status indicator (blue warning light on the dash) will
blink steadily, once per second. To arm the system silently, press and hold the LOCK
icon button for 1 second. The parking lights will flash 2 times, indicating the system
is armed, has locked the doors (if equipped and connected) and activated the starter
disable feature. The status indicator (blue warning light on the dash) will blink
steadily, once per second. When using the 2-way confirming LED remote control the
LOCK icon will flash 1 time and the remote control will beep/vibrate 1 time. The
LOCK icon LED on the remote control will flash 1 time evry 10 seconds to indicate
the system is armed and the vehicle doors are locked.
Pre-arm Mode
If the system sounds and the parking lights flash only once, this indicates that the
vehicle’s interior light is on or an entrance is left open. Check to see that all doors
hood and trunk are closed properly. Once all entrances are secured (and the
interior light is off), this system will sound/flash again. The system is now fully
armed. (If the entrance is not secured within 4 minutes, the system will arm and
ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK icon button. The system will sound and
the parking lights will flash once, and the doors will unlock (if equipped and
connected). To disarm the system silently, press and hold the UNLOCK icon button for 1 second. The
parking lights will flash, indicating the system is disarmed and has unlocked the doors (if equipped and
connected). When using the 2-way confirming LED remote control the UNLOCK icon will flash 1 time
and the remote control will beep/vibrate 2 times. The UNLOCK icon LED on the remote control will flash
1 time evry 10 seconds to indicate the system is armed and the vehicle doors are locked.
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation
chirps.
. Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times
when disarming the system. Enter the vehicle an observe the dash mounted status LED to Identify
which zone was triggered.
1. IT-s Sensor- 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch- 2 flashes, pause 2 flashes, etc.
3. Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more
than 2 seconds.
3
