Press ALT key to exit programming and save or press CLEAR to exit programming without saving.
HORN RING TRANSFER FUNCTION:
The connection process is the same as standard Sprinter unit. CONNECTING THE GREY WIRE TO
GROUND WILL ACTIVATE THE HORN RING FUNCTION.
When the Wail key is depressed, grey wire has the same function with Emergency key, using to shift
between Wail and Yelp.
TROUBLESHOOTING:
PROBLEM
PROBABLE CAUSE
REMEDY
No siren output
shorted speaker or speaker wires
check connections and wire ways
Fuse Blows
amplifier wires reversed polarity
check polarity of wire connections
Siren tone volume low or garbled
low voltage to siren amplier, high
resistance in wiring/ defective spkr.
check wiring for bad connections,
check spkr wiring, replace speaker
High rate of speaker failures
high voltage to siren, 58 W speaker
connected-(58 W spkr not allowed)
check vehicle charging system,
install 100W speaker in system
Backlight will not light or adjust
parklight input must have +24V for
backlight to function on controller
engage parklights on vehicle if
wired into system. or apply +24V.
to parklight circuit input on Amp.
Auxiliary lights do not operate IE:
alley, TD , sign board, headlight
flashers
short ciruit of wiring for light in
question, internal fuse blown in
amplifier
check wiring and connections to
lights in question, check and re-
place fuse in amplifier circuit
SPECIFICATIONS AND MAINTENANCE:
Specifications:
Siren Section
Input Voltage 24VDC (negative ground)
Input Current 5 Amps @ 27.2VDC
Output Voltage Maximum 100W @ 24VDC
Operating Temperature -30 °C to +65 °C
Dimensions (HWL):
Handheld controller 0.65”X 2.0”X3.7”
Amplifier 2.0″X3.6″X7.6″
Weight – Siren (approx): 4.0 lbs
Weight – Controller (approx): 0.5 lbs
Base: Black powder coat painted aluminum extrusion
Mounting – Siren: 4-hole flange mounting on base
Mounting – Controller: (Not specified), (4 mounting holes provided on base)
Compliance: SAE J1849, California Title 13
Warranty: 5 years
T56095 Rev. A
Page 19 of 22
