23
3.5 Remote control inputs (Ethernet)
The Ethernet Link network connector allows you to access the LINUS10 from a host computer for remote control, firmware
update and download ing DSP presets. Please note that for setting up proper network connec tion you need to use the
CODA Audio LINUS Control
software (download online: www.codaaudio.com).
3.6 Power outputs
Both SPEAKON® connectors are connected to the channel A and channel B amplifier outputs. Note that the wiring
configuration of the second (bottom) SPEAKON® connector is inverted (channel A and B outputs swapped).
LINUS10
3. INSTALLATION
The pin configuration of the SPEAKON® connectors is as follows:
Upper
SPEAKON®
Pin 1 +
Channel A amplifier output
Pin 1 -
Channel A ground
Pin 2 +
Channel B amplifier output
Pin 2 -
Channel B ground
Bottom
SPEAKON®
Pin 1 +
Channel B amplifier output
Pin 1 -
Channel B ground
Pin 2 +
Channel A amplifier output
Pin 2 -
Channel A ground
WARNING! SPEAKON® connectors marked with the lightning flashes indicate high voltages that are potentially life
threatening. Wiring to these terminals requires installation by an instructed person or the use of ready-made leads or
cords. Custom wiring should only be carried out by qualified personnel.
To prevent electric shock, do not operate the amplifier with any of the conductor portion of the speaker wire exposed.
NOTE: For reasons of safety and performance do only use high-qual ity fully insulated speaker cables of stranded
copper wire. Use the largest wire size that is economically and physically practical. Make sure that the cables are not
longer than necessary.
3.7 Dual channel operation
Two fully independent amplifier channels
(aka "Stereo" - normal operating mode).
Zmin = 2 Ω for dual channel operation
3.8 Sensor cable connections