Cocoon FPV HD Camera Drone, Instruction Manual

Page: 15 / 28

1300 663 907
15
After Sales Support
Model Number
HE180101
customercare@winplus.com.au
Setup & Installation
2.3 Install the Camera and Propeller Guards
a.
Connect the camera wires to the plug port located on the base of the drone. Coil any
remaining cable into the cavity
b.
Insert the camera into the base of drone by twisting the camera 90 degrees into place until you
feel a ‘click’ and some resistance
c.
Push the propeller guard into the slot and push the lever down until you hear a ‘click’
NOTE:
• Ensure the camera is facing the head of the drone as illustrated on page 12. It should be facing away
from the battery if you are looking at the drone’s base
• To remove the camera, twist the camera 90 degrees to the right and unplug the wire
2.4 Installing the Phone Holder to use your Smartphone
If you are only using the remote control to operate the drone, you do not need to install the phone
holder. It is ideal to use the phone holder when you want to use your smartphone to take photos
and videos whilst still using the remote control to fly the drone.
To install the phone holder, turn the remote over and:
a. Slide out the cover on the remote control as illustrated
b. Insert the phone holder connector to the top of the remote
control by sliding it down into place
c. Press the ends of the phone holder to open and insert a
smart phone. Release to secure device
d.
Ensure the device is secure before proceeding. Winplus
Australasia does not take any responsibility for devices that
fall from the phone holder
e.
Press the ends of the phone holder to open & release device
f.
To remove the phone holder, press down on the moulded
grooves at the back of the remote control and push up to
release it