To reset your program after using T or MT push all three buttons
together (Increase, Decrease and Select) for a few seconds. Your
processor will reset the program to microphone (M) as well as the
sensitivity and volume levels if they were adjusted.
Disable the telecoil when not using the telephone, as it can
reduce the microphone volume.
From accessory to telecoil
To move to the in-built telecoil when an accessory is attached, push
both the Increase and Decrease buttons at the same time, for a few
seconds, until a T shows on the display.
From telecoil to accessory
To move back to the accessory, push both the Increase and Decrease
buttons at the same time, for a few seconds, then repeat this until
you can hear with the accessory again.
From accessory to microphone
Alternatively you may wish to move from using your accessory, to
using your microphone only, while leaving the accessory attached.
When using an accessory, to move to the microphone only setting,
push both the Increase and Decrease buttons at the same time, for
a few seconds, then do this again, until an M shows on the display
(except when using a lapel microphone) or you hear sound through
the microphone.
From microphone to accessory
To move back to the accessory, push both the Increase and Decrease
buttons at the same time, for a few seconds, until you can hear the
accessory again.
Make sure your fi nger presses both sides of the button area.
Locking the buttons
The button lock can be used to prevent children from changing
the controls or to avoid accidental button presses changing your
processor settings.
© Cochlear Limited 2009
Freedom Hybrid User Guide - 31
Usin
g
182630 Hybrid SP User Guide ISS2 D02 RJD.indd 31
182630 Hybrid SP User Guide ISS2 D02 RJD.indd 31
3/08/2009 12:44:12 PM
3/08/2009 12:44:12 PM
