background image

                            SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS                   REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for  installation purposes that must be executed
as per the instructions given on the product installation manual.

danub98gbb.doc

MAKE

DAEWOO

MOD.

NUBIRA

YEAR

98 

PETROL
DIESEL

ALARM/SIREN
POSITION

Position the compact alarms and the sirens in the engine compartment near the
left lateral headlamp. Position the modular systems and the modules under the
dashboard, drivers side.

POWER SUPPLY

+ 30: 

connect to the 2,5mm

2

 RED wire located at the rear of the left lateral frame,

drivers side.

- 31:

 connect with an eyelet cable terminal to one of the fastening bolt of the

dashboard.

DIRECTION INDICATORS

Connect to the 1 mm

2

 BLUE and LIGHT BLUE wires located  in the wiring

harness  and coming out of the 22 way yellow connector located on the support of
the connector holder, above the fuse box behind the left lateral frame, drivers
side.

ELECTRIC WINDOWS

Positive control signal
Front window, driver’s side:

cut the BLUE wire directly outgoing from the switch of the window to the inner
drivers side door.

Front window, passenger’s side:

cut the 1,5 mm

2

 LIGHT BLUE wire.

Rear window, driver’s side:

cut the 1,5 mm

2

 BROWN wire.

Rear window, passenger’s side:

cut the 1,5 mm

2

 GREEN wire located in the wiring harness coming out of the

drivers side door.

CENTRAL DOORS LOCKING

Negative control signal

Connect to the LIGHT BLUE wires with WHITE reference located at the position
nr. 7 (lock) and the YELLOW  at the position nr. 1 (unlock), in the 9 way white
connector of the central door locking unit located at the rear of the left lateral
frame, drivers side.

Note: for the vehicles without original key less entry, please refer to
diagram nr. 42 for the serie Bridge antithefts or refer to diagram nr.42A for
serie 3100 antithefts.

IMMOBILISATION POINT

The vehicle has an original equipment immobiliser that may be enabled
immediately when the switchboard is switched off.

BONNET SWITCH

Install an additional switch on the front headlamp support plate.

DOORS SWITCH

Connect to the 0,5 mm

2

 WHITE wire located in the wiring harness coming out of

the 16 way white connector, on the support of the connector holder, above the
fuse box behind the left lateral frame, drivers side.

BOOT SWITCH

Connect to the 0,5 mm

2

 PINK wire with BLACK reference located in the wiring

harness and coming out of the 16 way white connector located on the support
mentioned above.

X

Reviews: