COBRA INSTALLATION AND PROGRAMMING GUIDE
Introduction / Tools and Materials Needed
57010-H Page 2 12-19-2005
COBRA INSTALLATION AND PROGRAMMING GUIDE
Introduction / Tools and Materials Needed
Introduction
The MPC Cobra is a battery-powered manually programmed access control sys-
tem. Up to 100 individual codes can be programmed right at the keypad. A red and
green LED on the keypad provide visual indication for programming and access
events. Mechanical key override is possible when a 7-pin small-format inter-
changeable core (not included) is installed in place of the cylinder plug, which
comes standard. Either the plug or the IC core must be installed for the lock to
operate. When the cylinder is removed (using the cylinder control key) the lock
will unlock. Manual key override should only be necessary if the low battery out-
put indications have been ignored. (See also
BATTERY INFORMATION:
on page 10
).
The design allows for mounting on doors from 1-1/2” to 2” thick. A shim is avail-
able to mount the lock to a 1-3/8” door. An exterior gasket (EG option) is available
for application to exterior sides of doors.
Tools and Materials Needed
1.
Philips head screwdriver set
2.
Allen wrench set
3.
Loctite 242
4.
4 “AA” Batteries (provided)
The following will also be needed only for new installations:
5.
Full size door template (provided)
6.
Pencil
7.
Center Punch
8.
Hammer
9.
Chisel
10. Square
11. Level
12. Masking tape
13. Drill w/chuck for up to 1” drill bits
14. Drill bit set
15. 2-1/8” Hole saw
