3
2
For charging microTALK radio(s) in desktop
charger:
1.
Insert radio(s) into desktop charger as
shown.
2.
Insert round connector of 120-volt adapter
into jack on back of charger.
3.
Plug 120-volt adapter into electrical outlet.
If charging light is not
on
, check position of radio. Radio should
be upright. The charge indicator light will stay
on
as long as the
radio is in the charging well
.
It normally takes about 15 hours to fully recharge battery pack.
Battery pack will not be damaged if it stays in the charging well
longer than that.
Note:
To charge a single radio, you can bypass the desktop
charger and simply insert the wall adapter’s round connector
directly into the speaker/microphone/charge jack located on the
top of the radio.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK radio.
Cobra recommends your radio is turned
off
while being charged.
Turning on Your microTALK Radio
•
Press and hold the
Power
button until you
hear a series of audible tones indicating the
radio is
on
.
Your microTALK radio is now in
Standby
mode,
ready to receive transmissions. The radio is
always in
Standby
mode, except when the
Talk
,
Call
or
Power
buttons are pressed.
Battery Low
•
When battery power is low, the
Battery Low
icon
will blink. Your batteries should be recharged
Auto Battery Save
•
Your microTALK radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to
Battery Save
mode and
the
Power Saver
icon will flash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
Communicating with Another Person
•
1.
Press and hold the
Talk
button.
2.
With the microphone about 2 inches
(5 cm) from your mouth, speak in a
normal voice.
3.
Release the
Talk
button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the
Talk
button.
Both radios must be tuned to the same
channel/privacy code to communicate.
Introduction
Using Your Radio
Customer Assistance Warranty
Introduction
Operation
On/OffPower
BatteryLow
BatterySaveMode
TalkButton
InsertRadio(s)
Quick Start
1.
Press and hold the
Power
button to turn
on
your radio.
2.
Press the
Channel Up
or
Channel Down
button to select a channel.
Both radios must be tuned to the same
channel/privacy code to communicate.
3.
Press and hold the
Talk
button while
speaking into the microphone.
4.
When finished talking, release the
Talk
button and listen for a response.
2Inches(5cm)from
Mouth
Nothing
Comes Close to a Cobra
®
CXR725C_MANL_ENG.indd2-3
12/15/092:10PM
