15
11. STORAGE
The following steps should be taken in order to prepare the lawn mower for storage.
1. Remove the battery pack from the mower and store it at room temperature in a dry location.
2. Clean the mower as described earlier in the maintenance section.
3. Inspect the blade and replace it or sharpen it if required.
4. Check and lubricate where possible.
5. Store the mower in a dry and clean location. Do not store it next to corrosive materials, such as fertilizer or
rock salt.
6. Store the mower in a covered, enclosed space, that is cool and dry and out of the reach of children.
7. Do not cover the lawn mower with a solid plastic sheet. Plastic coverings trap moisture around the mower,
which causes rust.
12. TROUBLESHOOTING
Fault Remedial action
Motor does not run
Turn power on
Start on short grass or on an area which has already been mown.
Clean discharge channel/housing
–the mowing blade must rotate freely.
Correct the cutting height.
Thermal cut out activated, allow the motor to cool and increase height of cut
Motor power drops
Correct the cutting height.
Clean the discharge channel/housing
Have mowing blade re-sharpen or replaced. See a Cobra dealer.
Grass catcher is not filled
Correct the cutting height
Allow the lawn to dry
Have mowing blade re-sharpen or replaced. See a Cobra dealer.
Clean the grille on the grass catcher
Clean the discharge channel /housing
Motor runs intermittently
Thermal cut out activated, allow the motor to cool and increase height of cut
Machine leaves ragged finish
Height of cut too low, increase the height of cut
Cutting Blade Blunt, have the blade re-sharpen or replaced. See a Cobra
dealer.
Warning
: Before performing any maintenance or cleaning work, always remove batteries and switch off
the isolator key! Proceed only once the motor and blade are stationary.
CAUTION!
Faults which cannot be rectified with the aid of this table may be rectified with the assistance
of a Cobra dealer.