Cobra CB6, Service Manual, Page: 20 / 34

6
Service Procedures
16
Revision 2
© Moffat Ltd, August 2012
Cobra Series Gas Barbeque
6.2.9 Gas Control Valve
1) Remove the control panel (refer 6.1.1).
2) Undo the pilot supply, main supply and
disconnect the thermocouple from gas control
valve.
3) Undo the compression nut securing gas
control to the manifold assembly.
4) Remove the gas control valve.
5) On suitable work surface, remove rear nut
from gas control.
6) Extract the gas control magnet.
7) Replace and re-assemble in reverse order.
Figure 6.2.9
Magnet
Rear Nut
6.2.10 Gas Control Magnet
1) Remove the control panel (refer 6.1.1).
2) Undo the pilot supply, main supply and
disconnect the pilot thermocouple from the
gas control valve.
3) Undo the compression nut securing the gas
control valve to the manifold assembly.
4) Replace gas control and re-assemble in
reverse order.
NOTE: Ensure that the correct size injector
is re-fitted to gas control (refer to
the ‘Specifications’ section).
5) Adjust low fire setting (refer 6.3.2).
Figure 6.2.10
Gas Control Valve
Manifold Gas
Connection
Main Burner
Gas Supply
Thermocouple
Connection
Pilot Supply