®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa.com
04/17
®
Instruction Manual >
602-2005/602-2005B
Page 3 of 3
15.
Pull backward on both detachable latch knobs and then push downward on the backrest to allow the
backrest to sit completely on the rear mounting bushings. Then release the detachable latch knob to
fully engage the latch pin underneath the mounting kit bushing. See
FIGURE 6.
16.
Always check to make sure both detachable latch pins are fully engaged on the bottom of the
mounting kit bushing. Failure to fully engage the detachable latch pin could cause the backrest to
come loose while riding. See
FIGURE 6.
17.
Pull backward on the top of the sissy bar and then tighten all four M8 X 20mm bolts. See
FIGURE 6.
18.
Before each ride, check to make sure the detachable latches are fully engaged underneath the
mounting bushings.
19.
Check the tightness of all the screws after the first ride and after the first 500 miles.
DOCUMENT NO. 0018
REV. A
REAR MOUNTING
BUSHING
FRONT MOUNTING
BUSHING
DETACHABLE
LATCH KNOB
DETACHABLE
LATCH PIN
FIGURE 5
MAKE SURE LATCH PIN
IS FULLY ENGAGED
UNDER BUSHING
FIGURE 6
TIGHTEN ALL FOUR
M8 X 20mm BOLTS
To clean your black accessory use a liquid based soap detergent, such as dishwashing soap applied with a soft cloth and
rinse with clean water. Note: Avoid abrasive cleaning methods such as granular or dry cleansers, simple green, Scotch-
Brite or steel wool pads. Abrasives may breach the coating and shorten life.
