Page 7
For technical questions, please call 1-888-866-5797.
Item 58197
Before Mounting
1. Test that the Camera functions
properly by connecting it to the
Power Adapter and AC outlet.
2. After testing Camera, plan
mounting location and angle:
a. Consider the distance of the AC
outlet to the Power Adapter and
Camera. Use the Extension Cable
if necessary. Route the Cable so
as to avoid a tripping hazard.
b. Choose a location high enough so
that it is out of reach of children, but
still covers the desired viewing area.
CAUTION!
The Power Adapter MUST be
plugged in indoors in a clean, dry location.
c.
Verify that installation surface
has no hidden utility lines before
drilling or driving screws.
d. Avoid mounting the Camera
upside down. Make sure the
Hood is above the Lens.
e. Make sure no strong light will
shine directly into Camera Lens.
3. Using the Base as a template,
mark locations of mounting
holes on mounting surface.
Note:
Route Cable through Notch
on the Base to keep Base flush with
mounting surface while marking holes.
Mounting
Holes
Notch
Bottom of Camera’s Mounting Base
Mounting
Note:
Drill bits and Drill sold separately.
Solid Surface
1. Using a drill bit slightly smaller
than the Screws, drill pilot holes
into the marked locations.
2. Position Camera so that mounting
holes align with pilot holes.
Note:
Route Cable through slot on Base
to keep Base flush with mounting surface.
3. Drive Screws through mounting
holes in Base and into pilot holes
until the Camera is securely
attached to the mounting surface.
Hollow Surface
1. Using a drill bit the same diameter
as the Anchors, drill holes in
the marked locations.
2. Tap Anchors into the holes until they
are almost flush with mounting surface.
3. Position Camera so that Mounting
Holes align with anchor holes.
Note:
Route Cable through slot on Base
to keep Base flush with mounting surface.
4. Drive Screws through mounting
holes in Base and into anchor
holes until the Camera is securely
attached to the mounting surface.
