INSTALLATION MANUAL 4600 CAN/PLIP
18
9. - FUNCTIONAL TEST.
During the
fi
rst 25 s after the system has been armed all protection functionalities can be tested without triggering an alarm.
Make the following tests during the 28 s inhibition time with the system armed:
open
then close one by one all doors and boot
- Check if the system is con
fi
rming with three audible signal, each door
opening detection.
Check the proper functionality of the volumetric ultrasonic sensor
- Make movements from the back seat, their detection
will be con
fi
rmed by a LED
fl
ashing.
Note
:
don’t check the proper functionality of the volumetric ultrasonic sensor with the windows opened as many CAN applications
are automatically excluding this protection when the windows are left opened.
Open the bonnet then lock the vehicle with the remote control
- While arming the system will indicate the bonnet opening
with 3
fl
ashes of the direction lights and correspondingly with audible signals.This test is applicable only if the signal is detected
from the CAN network or for systems wired siren.
Try to start the engine
- If the engine cranking wires have been connected the engine will not start.
Warning
: on some vehicle
by turning the ignition key ON the system will disarm (TRANSPONDER detection).
Check if the PIN emergency Code works properly
- By correctly entering the PIN code the system disarms.
10. - CAN / PLIP INDEX MANUAL SELECTION.
The technical support could ask you to manually select a different CAN / PLIP index of the brand which has been loaded in
the main unit. To select a different CAN / PLIP application (CAN INDEX) proceed as follows:
as soon as the system is powered - in the disarming state - the emergency panel LED
fl
ashes quickly for 5 s, during this time
frame keep pressed the emergency panel pushbutton until it will go off then release it. The LED starts
fl
ashing slowly a number
of time corresponding to the already set index (example 3
fl
ashes for index 3).
While the LED is
fl
ashing slowly, press brie
fl
y the button of the emergency panel to switch to the next index; each time you press
the button the index increases and so on. By pressing again when the last index has been selected the system will switch back
to the
fi
rst one of the list. Select the correct CAN / PLIP index, then wait for the LED off to con
fi
rm the current index selection.
Note1
: the same CAN index can be used for many vehicle models, check the CAN INDEX table available on the web.
Note2
: there are four PLIP index available, check the vehicle speci
fi
c PLIP installation sheet or the PLIP application manual
available on the web in the “Application Manuals” section.
11. -
SELF LEARNING PROCEDURE REQUIRED TO REPLACE THE MAIN UNIT OR THE WIRELESS
SIREN REPLACEMENT.
The siren supplied in the kit is delivered already programmed to the main unit. Should you have the need to replace the siren
or the main unit it is required to perform the self learning procedure as follows:
IMPORTANT
: don’t perform the procedure on two different vehicles parked closed each other. Their sirens could be memorized
in one main unit only.
A. Power the main unit by connecting the 26 ways connector.
B. Connect the main unit blue wire to GND (only when a wireless siren is
fi
tted).
C. Open the bonnet.
D. Connect the siren blue wire to GND (if not already grounded through the additional bonnet
pushbutton).
E. Disconnect the siren 6 ways connector, then plug it again.
F. Within 60 s turn the ignition key ON, an audible signal con
fi
rms that the siren has been stored in the system.
G. Turn the ignition key OFF and disconnect the BLU wires of the main unit and of the siren from GND (if grounded through
the additional pushbutton simply open the bonnet).
Check the system functionality arming the system and triggering the alarm to check the proper sounding of the siren.
