![background image](http://html.mh-extra.com/html/cobra/2010-gtl-wx/2010-gtl-wx_operating-instructions-manual_2631060013.webp)
OPERATING PROCEDURE TO RECEIVE WEATHER BAND continued
3. If threatening weather is nearby, the National Weather Service may broadcast
a 10 second alert tone. This tone will be heard through the CB, even if the
WX/CB Switch is in the CB mode or the unit is turned off (see NOTE below).
This enables you to monitor CB frequencies and still be warned by the
National Weather Service Emergency Alert. When you hear the alert, place
the WX/CB Switch in the WX position. You will then be able to hear the
Weather Warning Broadcast.
NOTE: If you are using the CB Mode, remember to change the WX/CB Switch
from CB to WX every so often to make sure you are continually tuned to the
clearest weather band channel in case an alert is broadcast.
FREQUENCY COUNTER/LCD DIGITAL CLOCK
1. Located on the right side of the LCD is the Counter/Clock Indicator.
2. For proper procedure to set your LCD Clock, there are the following features:
TIME SET: 2 switches (used to set time).
COUNTER/CLOCK: 1 switch (used to select display).
TO SET TIME
1. Press FREQ. CTR./CLOCK Switch to select the clock.
2. HOUR SWITCH: Press this switch to get correct hour setting.
3. MINUTE SWITCH: Press this switch to get correct minutes setting.
NOTE: the 2010 GTL WX uses a 24-hour clock display (no a.m. or p.m. indi-
cated). Example:
Display Reads
Time Is:
01:00
1:00 a.m.
12:00
12:00 noon
18:00
6:00 p.m.
24:00
12:00 midnight
FREQ. CTR./CLOCK:
On power up, the display shows
channel number and frequency being
received. Pressing thr FREQ. CTR./
CLOCK button will select the Clock.
Clock mode only is displayed in the
WX (weather) mode. When switching
out of WX mode, the display will
continue to show the clock until the
FREQ. CTR./CLOCK button is pressed
again.
Section IV Operation (Continued)
Cobra
®
2010 GTL WX
R X L S B
:
H O U R
M I N
F R E Q . C T R .
C L O C K
Display in RX mode with Clock showing.
11