![background image](http://html.mh-extra.com/html/cobra/2010-gtl-wx/2010-gtl-wx_operating-instructions-manual_2631060011.webp)
9
SWR CAL
SWR
MOD
CAL
LSB
AM
USB
MIN
FREQ. CTR
CLOCK
AM / SSB BASE STATION WITH WEATHER ALERT
AM / SSB BASE STATION WITH WEATHER ALERT
HOUR
VOICELOCK
MAX
MIN
RF GAIN
DYNAMIKE
POWER
PHONE
VOLUME
MIC
SQUELCH
COARSE
NB
SWR
CAL
100%
0
1.5
2
3
MOD
SIGNAL
+30
R X
TX
ANT
USB
LSB
AM
0
1
9
8
10
7
6
5
4
3
11
12
13
14
15
16
17
18
19
20
3
2
5
9
3
4
RF PWR
ANL
TUNING
WX
CH 9
2010 GTL WX
Section IV Operation (Continued)
INDICATOR FUNCTIONS
1.
MODULATION METER. Indicates the percent modulation (AM only).
NOTE
The SWR/SWR CAL/MOD switch must be in the
MOD position to read modulation.
2.
SWR METER. Measures the ratio of standing wave voltage of the antenna system.
Used to properly adjust the length of the antenna, and to monitor the quality of
the coaxial cable and all RF electrical connections. If there is any degradation
whatsoever in any of the above, due to humdidity, salt spray, vibration or
corrosion, the SWR meter reading will rise, therby indicating that a problem exists.
To calibrate, switch to the CAL position. Transmit by pressing the mic switch (AM
mode), and adjust the SWR/CAL control to the CAL mark on the meter. Then
switch to SWR position for the SWR measurement.
3.
S/RF METER. Indicates relative output power and incoming signal strength.
4.
CHANNEL INDICATOR. The selected channel appears on the LCD left of the
channel selector knob.
5.
RECEIVE INDICATOR (RX). Appears in LCD.
6.
TRANSMIT INDICATOR (TX). Appears in LCD.
7.
MODE INDICATOR (USB/LSB/AM). Mode appears in LCD when set by mode
selector.
8.
ANTENNA WARNING INDICATOR. Appears on the lower left corner of the LCD
if there is a serious degradation of the antenna system SWR due to humidity, salt
spray, vibration or corrosion.
1
2
3
4
5
6
7
8