Double - Sided
Adhesive Tape
Battery
Battery Tray
Batteries
The Goblin has a quick release battery tray system.
The batteries must be installed onto the battery tray to take advantage of the quick release locking system.
Install the battery to the battery tray using double sided tape and the long Velcro straps included.
Make sure to find the right position of the battery to optimize the center of gravity.
To insert the battery, simply align the battery tray in the slots at the front of the helicopter and slide all the way. The battery will
lock in place.
To remove the battery, simply lift up on the locking lever (Fig 4) and pull.
IMPORTANT:
Make sure the battery is locked in place before flight; the battery tray must be inside the slots on both sides! When
removing the battery, pull gently on the locking lever, using excessive force can break the area of carbon that supports the locking
lever damaging the quick release mechanism.
The canopy touches the frames on the Goblin, this is normal and expected as it is part of the
design. To avoid canopy damage due to high frequency vibration, it is necessary to attach the
adhesive foam tape HA006 to the canopy. [Bag 8] (Fig 5).
Install the canopy grommets [Bag 8] as shown in Figure 5.
The canopy locks in the front as shown by the arrow in Figure 6 and in the rear by the canopy
screws H0248 [Tray 2] (Fig 7).
Canopy
Copyright@2013 - SAB Heli Division - All rights reserved
Page 25
Chapter 15, Battery / Canopy
Summary of Contents for Goblin 500
