To modify the Antenna
98-155944-A
Chapter 1: Conversion to Ku-band
7
Conver
sion to
Ku
-band
5. Fit the Tx cable behind the reflector and connect the angled connector of the cable to
the N-connector on the antenna. See Figure 10.
6. Take the cable harness and connect the GTC C4 connector behind the reflector.
7. Arrange the 3 cables in the cable harness together with the Tx cable and the 2 remaining
cables from the eTRIA installation and fit them all in the protective sleeve (6 cables in
total). The previous eTRIA cable will be reused as the Rx cable for the LNB and the GNSS
cable is reused as is.
8. Cut some of the cable strips that hold the existing cables on the Feed arm. Leave some
of them to hold the cables in place until the new cables are arranged.
Figure 10: Connect and arrange cables
Figure 11: Fit cables in protective sleeve
Figure 12: Cut cable strips
GTC C4
connector
N-connector
Protective
sleeve
Cable strips
Summary of Contents for EXPLORER 8100 Ku
Page 1: ...EXPLORER 8100 Ku Conversion Kit Hardware installation guide...
Page 2: ......
Page 21: ......
