DIGIMINI AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless
–
Coverage
Date: 6-Jul-17
www.cobham.com/wireless
Doc. No.: 00031UM
Rev. 6.3
Page |
VII
General Safety Warnings Concerning
Always observe standard safety precautions during installation, operation and maintenance of this product.
Caution labels!
Throughout this manual, there are "Caution" warnings. "Caution" calls attention
to a procedure or practice, which, if ignored, may result in injury or damage to
the system, system component or even the user. Do not perform any procedure
preceded by a "Caution" until the described conditions are fully understood and
met.
Danger: Electrical
Shock
To prevent electrical shock when installing or modifying the system power wiring,
disconnect the wiring at the power source before working with un insulated wires
or terminals.
Caution: Safety to
personnel
•
Before installing or replacing any of the equipment, the entire manual should be
read and understood.
•
The user needs to supply the appropriate AC or DC power to the repeater.
Incorrect power settings can damage the repeater and may cause injury to the
user.
•
Please be aware that the equipment may, during certain conditions become
very warm and can cause minor injuries if handled without any protection, such
as gloves.
Caution: Safety to
equipment
•
When installing, replacing or using this product, observe all safety precautions
during handling and operation. Failure to comply with the following general
safety precautions and with specific precautions described elsewhere in this
manual violates the safety standards of the design, manufacture, and intended
use of this product.
•
Changes or modifications not expressly approved by the party responsible
•
for compliance could void the user’s authority to operate the equipment
•
Axell Wireless assumes no liability for the customer's failure to comply with
these precautions. This entire manual should be read and understood before
operating or maintaining the repeater.
Warning: Restricted
Access Location
Access to the Axell unit installation location is restricted to SERVICE PERSONNEL
and to USERS who have been instructed on the restrictions and the required
precautions to be taken.
Attention: Electrostatic
Sensitivity
•
Observe electrostatic precautionary procedures.
•
ESD = Electrostatic Discharge Sensitive Device.
•
Static electricity can be conducted to the semiconductor chip from the centre
pin of the RF input connector, and through the AC connector pins. When
unpacking and otherwise handling the repeater, follow ESD precautionary
procedures including use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
