BBG1003UDXADDA-OM (V1.2)
BBG-1003-UDX-ADDA PRODUCT MANUAL
2-1
Chapter 2
Chapter 2
Installation
Overview
This chapter contains the following information:
•
Installing the BBG-1003-UDX-ADDA (p. 2-1)
•
Rear Panel Connections (p. 2-2)
•
GPIO, Serial (COMM), and Analog Audio Connections (p. 2-5)
Installing the BBG-1003-UDX-ADDA
Note:
• Where BBG-1003-UDX-ADDA is to be installed on a mounting plate (or
regular table or desk surface) without optional frame Mounting Tray
BBG-1000-TRAY, affix four adhesive-backed rubber feet (supplied) to the
bottom of BBG-1003-UDX-ADDA in locations marked with stamped “x”. If
feet are not affixed, chassis bottom cooling vents will be obscured.
• Where BBG-1003-UDX-ADDA is to be installed with optional frame
Mounting Tray BBG-1000-TRAY, do not affix adhesive-backed feet.
Installing Using BBG-1000-TRAY Optional Mounting Tray
BBG-1000-TRAY
allows up to three BBG-1003-UDX-ADDA to be mounted
and securely attached to a 1 RU tray that fits into a standard EIA 19” rack
mounting location. Install BBG-1003-UDX-ADDA unit into tray as described
and shown here.
1.
If installing BBG-1003-UDX-ADDA using optional frame Mounting
Tray BBG-1000-TRAY, install BBG-1003-UDX-ADDA in tray as
shown in Figure 2-1.
2.
Connect the input and output cables as shown in Figure 2-3.
