2
Rear Panel Connections
2-2
BBG-1002-UDX-FS PRODUCT MANUAL
BBG-1002-UDX-FS-OM (V1.0)
Figure 2-1 Mounting BBG-1002-UDX-FS Using Frame Mounting Tray
BBG-1002-UDX-FS Unit Dimensions
Figure 2-2 shows the BBG-1002-UDX-FS physical dimensions and mounting
details for cases where BBG-1002-UDX-FS will be installed in a location not
using the optional
BBG-1000-TRAY
mounting tray.
Rear Panel Connections
Perform rear panel cable connections as shown in Figure 2-3.
Note:
• The BBG-1002-UDX-FS BNC inputs are internally 75-ohm terminated. It is
not necessary to terminate unused BNC video inputs or outputs.
• External frame sync reference signal (if used) must be terminated if a
looping (daisy-chain) connection is not used. Unterminated reference
connection may result in unstable reference operation.
1
From front of tray, slide unit into tray, aligning with
tray edge and/or guides
2
Slide unit (rear) fully to rear of tray. Secure unit to
tray using captive fastener. Tighten only finger tight.
Note: BBG-1002 will not align with tray captive
fastener if rubber feet are affixed to
bottom of BBG-1002.
Remove rubber feet if BBG-1002 is
being installed in tray.