9903UDXADDA-OM (V1.5)
9903-UDX-ADDA PRODUCT MANUAL
2-3
Installation and Setup
Installing a Rear I/O Module
Note:
If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be
discovered by DashBoard™ and be ready for use.
Installing a Rear I/O Module
Note:
This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9903-UDX-ADDA is to be installed.
If installing the 9903-UDX-ADDA in a slot already equipped with a suitable
I/O module, omit this procedure.
Install a Rear I/O Module as follows:
1.
On the frame, determine the slot in which the 9903-UDX-ADDA is to be
installed.
2.
In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-1.
Figure 2-1 Rear I/O Module Installation
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
1
2
Summary of Contents for 9903-UDX-ADDA
Page 99: ......
