9931-EMDE-OM (V1.17)
9931-EMDE PRODUCT MANUAL
2-15
Installation and Setup
Connecting To Phoenix Terminal Connectors
Connecting To Phoenix Terminal Connectors
Figure 2-4 shows connections to the card Phoenix™ terminal block
connectors. These connectors are used for card analog audio, serial comm,
and GPIO connections. These terminal blocks use a removable screw terminal
binding post block which allows easier access to the screw terminals.
Note:
It is preferable to wire connections to Phoenix plugs oriented as shown in
Figure 2-4
rather than assessing polarity on rear module connectors. Note
that the orientation of rear module connectors is not necessarily consistent
within a rear module, or between different rear modules. If wiring is first con-
nected to Phoenix plug oriented as shown here, the electrical orientation will
be correct regardless of rear module connector orientation.
Setting Up 9931-EMDE Network Remote Control
Perform remote control setup in accordance with Cobalt
®
reference guide
“Remote Control User Guide” (PN 9000RCS-RM).
Note:
• If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt
®
reference guide Remote
Control User Guide (PN 9000RCS-RM) provides step-by-step instructions
for setting up network remote control of COMPASS™ cards using
DashBoard™. (Cobalt
®
OGCP-9000 and OGCP-9000/CC Remote Control
Panel product manuals have complete instructions for setting up remote
control using a Remote Control Panel.)
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
RM20-9931-XF-HV Expansion High-Ventilation
Rear Module
Used in conjunction with high-ventilation base Rear
Module RM20-9931-F-HV to provide the following
additional connections:
• Two analog balanced audio I/O (
AN-AUD I/O 1
and
AN-AUD I/O 2
; I/O function of each connection is
switch-configurable)
• Analog Y/composite, Pr/C, and Pb coaxial inputs
(Y/CVBS IN, Pr IN, and Pb/C IN, respectively)
• Analog Y/composite, Pr/C, and Pb coaxial outputs
(Y/CVBS OUT, Pr OUT, and Pb/C OUT,
respectively)
• Two fiber I/O (GUI configurable as I/O)
Note: • Analog inputs and outputs operational only with
appropriate card option +ANA and +ANV
installed.
• Available equipped with High-Density BNC
(HDBNC) or DIN1.0/2.3 connectors as:
RM20-9931-XF-HV-HDBNC or
RM20-9931-XF-HV-DIN, respectively.
Table 2-1
9931-EMDE Rear Modules — continued
9931-EMDE Rear Module
Description
Summary of Contents for 3G Fusion 9931-DE
Page 123: ......
