INSTALLATION GUIDE
Revision 2.6 - English version
Checklist for Installation
Please refer to user manual for proper procedure for carrying out the points
below.
OK
Error
Turn on the ignition and start the engine(s) with the key fob.
Check that the start sequence works correctly and as specified.
Check the radio range by moving the key device more than 20 meters away
from the boat to make sure that the wireless lanyard cord is functioning prop-
erly and stops the engine(s).
(The distance needed to stop the engine(s) on land can vary based on the
radio reflection where the boat is located)
Check that the key device vibrates and the signal beacon is activated when a
“Man overboard” situation is simulated.
The ignition is switched back on automatically 12 seconds after a man over-
board situation has occurred. Check that the engine(s) can be started directly
from the lock unit’s push button after a simulated man overboard situation.
Reset the system by taking control via the key fob by turning it off and then
back on by switching the main switch off and back on before the next test.
Enter the 4-digit PIN code provided with your CoastKey system by pressing
the lock unit’s button to unlock the system and check that the engine(s) starts
after the confirmation tone.
(Optional) Check that the aux. functions work from the key unit.
If connected to trim in a dual installation, check that both engines tilt in
parallel.
If connected to an anchor winch, the anchor must be secured with a strap.
Make sure the winch pulls in when you unlock the key-lock on the key fob.
Check that the manual ignition switch works normally when the lock unit is
disconnected. (The lock unit is disconnected by disconnecting the gray 8-pin
connector located 15 cm down the lock unit’s harness.)
When the system is disconnected, there are some types of engines that can
only be stopped using the manual lanyard switch.
The User Manual must be read before the CoastKey system is used.
Drivers and passengers must be informed of the lock units position and how to restart the
engine (s) in an emergency.
Take care of your owner’s manual as a future reference.
Disclaimer:
CoastKey AS will not be held responsible for any damage to personnel or property arising
from the incorrect use or installation of any CoastKey product.
It is mandatory to read the installation manual, user manual and complete the test and
security form before attempting any CoastKey installation.
Checklist for Installation
Test and Safety Form
