INSTALLATION GUIDE
Revision 2.6 - English version
The same procedure is done with the triangular gray 3-pin connector for the tilt
signals. On a side-mounted remote control you’ll find this connector in the same
area as the main connector.
On a top-mounted remote control you’ll find this connector on the signal cables
from the control handle.
Note: Exercise care when opening the side-mounted remote control.
The throttle and shift cables might be in tension and accidentally pop out
making it difficult to re-assemble the remote control.
3. Lanyard Switch
Drill a 16mm (5/8”) hole for the
engine kill switch provided with
the kit. Install it in a suitable place
in the console. (See Figure 4)
Connect the kill-switch’s wires to
the black and blue wire on Coast-
Key’s harness. (See Figure 5)
The kill-switch is provided with the
kit because the original manual
lanyard cord attached to the key
switch will stop operating when
the black wire with yellow stripe is
disconnected from the key switch.
Figure 4:
Figure 5:
