INSTALLATION GUIDE
Evinrude E-tec
Note:
Be careful when drilling holes to not damage other equipment.
Check the inside of the console for objects that might get hit by the drill-bit.
The engine can be started from the original key switch if the lock unit is
disconnected. In this case the engine must be stopped with the manual
lanyard cord provided with the kit as long as the black wire with yellow stripe
is disconnected from the ignition key switch.
4. The lock unit
Clean the surface where the lock unit is to be placed with acetone or similar, and
place it according to the guideline in “Installation checklist” located on page 2.
Plug the lock unit into CoastKey’s harness.
5. Test and Safety
Secure CoastKey’s harness and other loose wires with cable ties. Turn on the main
switch and complete the “Test and Safety Form” on the next page before you use
the boat for the first time.
Note:
If the boat is equipped with two engines, repeat the above installation
procedure for engine No. 2
