Page 12
Lampholder
Plastic Release Tabs
Dual Beam
Opto Sensors
Coin Chutes
4.8
Reel Mechanism
The reel mechanism is located on the rear of the pin perspex, with three illuminated graphics on the
reel band displayed through a clear window in the perspex. The reel band is removable by lifting
the two grey plastic tabs and then pressing inward on the roller assembly, which will click into the
retracted position, thus removing tension from the reel band It is probably best to release the reel
mech from its mounting if it is required to replace the reel band Illumination lamps may be
removed and replaced by releasing the PCB mounted lamp holder. This is simply a case of turning
the lamp holder a quarter turn anti-clockwise. The lamp is a push fit in to the lamp holder.
Refitting the reel band is a reverse proceedure, ensuring it is the correct way round for the plastic tab
to align with the optical position sensor. Lifting the plastic tabs on the front roller assembly allows
spring tension to be re-applied to the reel band.
4.8
Coin-In Sensor & Lockout
4.8
Coin-In Sensor Board
Coins enter via one of three coin chutes and pass through a dual beam coin sensor. These are
connected to an interface board, which generates a coin-in signal. This signal is directed to the
section logic board, which in turn activates the player section and increments the coin-in counter.
Summary of Contents for Jacks Hi
Page 21: ...Page 21 9 Electrical Schematic Diagrams ...
Page 28: ......
