sliding the box onto the two screws that are backed out. Lower the box so the
connectors mate together and screw into place with the 1/4-20 hex bolts. **Note-
Be sure the gray foam gaskets are securely in place around the black connectors
on the back of the tower.
13) Remove the top back panel on the upper section.
14) Install lamps and lenses on the Top Sign. The lenses need to be installed with
Red on the outer most row and then work into the orange, yellow, green, blue
and violet. Repeat as needed until reaching the center lamp with a clear
lens. **NOTE - The Center Lamp will be a repeating strobe and NOT a 60volt
lamp.
15) Slide Top Sign pole into the upper tower section and remove the back panel of
the Top Sign. Then run the wires through the hole in the tower section.
16) Connect all of the mating Molex connectors and reinstall the back panel on the
tower section.
17) Bolt the Top Sign onto the tower section using the hardware provided and BOTH
black gaskets. Re-install the back panel on the Top Sign.
18) Install the guy wire cables. The longest ones go to the upper section and the
shorter ones go to the lower section. For a 45' game there will be 3 different
lengths and 3 guy wire attachment points on the tower.
19) Install the 'Pull Up' cable to the same stud as the guy wire cable on the BACK of
the upper tower section. Remember when installing the guy wire cables Do Not
over tighten them. They should be snug, but the cable should be able to freely
move back and forth.
20) Test the tower. Things to check are:
•
Sound
•
LED boards
•
Strobe Boards for Proper tower height
•
Top Sign lamps and strobe
•
Skill Select operation
•
Bolts between tower sections are secure
•
Weatherproofing on Lexan and between tower section and Top Sign
•
All back panels are overlapping
•
LED gaskets are securely in place
•
Guy wires are secure
•
Top Sign bolted into place and back panel re-installed
•
Striker
21) Using a crane, lift the complete tower and lower it onto the studs mounted into
the concrete.
