OWNER’S MANUAL
2021
Main Pump
Auxiliary
Pump Lights
Temperature
CLASSIC SERIES TOPSIDE CONTROL PANEL
INITIAL START-UP
Your spa will enter Priming Mode (PR) when it is energized.
During Priming Mode, press “Jets” button repeatedly and
be sure the pump is free of air. Priming Mode lasts less than
5 minutes. Press “Warm” or “Cool” to exit. After Priming Mode,
the spa will run in Standard Mode (see Mode section).
TEMP CONTROL
(80°F - 104°F / 26°C - 40°C).
The last measured water
temperature is constantly dis-played. The water temperature
displayed is current only when the pump has been running for
at least 1 minute. To display the set temperature, press
“Temp” once. To change the set temperature, press the
temperature button again before the display stops flashing and
hold. The set temperature will begin to rise, release the button
at the desired set temperature. To decrease the set temperature,
press and hold the “temp” button again and the set temperature
will decline, release at the de-sired set temperature. After three
seconds, the display will stop flashing and begin to display the
current spa temperature. The spa will then begin heating
(or cooling) in order to reach the set temperature that you
have selected.
PUMP
Press “Pump” to turn the pump on or off, and to shift
between low and high speeds (if equipped). If left running, the
pump will turn off after a preset length of time. Low speed may
run automatically at times as part of your spas filtration
cycles, during which it cannot be deactivated from the panel,
however you will still be able to control the high speed setting.
The ozone generator (if installed) will activate anytime low speed
is running.
AUX (PUMP 2)
If an additional pump or blower is installed. Press “Aux” to turn
the device on. If your additional device is a dual speed pump,
pressing “Aux” again will activate the pumps high speed.
Pressing “Aux” again will turn off the device/pump.
LIGHT
Press “Light” to operate the spa light. Turns off after 4 hours.
If your hot tub is equipped with a multicolor lighting package,
then pressing the “Light” button con-secutively will toggle the
lights through different colors modes.
MODE
Mode is changed by pressing “Temp” then “Light’. Continue
Pressing the “Temp” then “Light’ button to toggle through the
available modes.
Leave the control for 10 seconds to exit.
Standard Mode
maintains set temperature. “St” will be
displayed momentarily when you switch into Standard Mode.
Economy Mode
heats the spa to the set temperature only
during filter cycles. “Ec” will display when water temp is not
current, and will alternate with water temp when the pump is
running.
Sleep Mode
heats the spa to within 20°F/10°C of the set
temperature only during filter cycles. “SL” will display when
water temp is not current, and will alternate with water temp
when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the spa is
energized. The second preset filter cycle begins 12 hours
later. Filter duration is programmable for 2, 4, 6, 8 hours, or
C for Continuous (all day). The default filter time is 2 hours.
To program, press “Temp” then “Pump”. Press “Temp” to
adjust. Press “Pump” to exit programming.
31
TRADITIONAL SPAS
