OWNER’S MANUAL
PURFIKT SPA
2021
Filter Cycle 2 - Optional Filtration
Filter Cycle 2 is OFF by default.
Viewing Filter 1 while Filter 2
is OFF
Viewing Filter 1 while Filter 2 is
ON
Adjusting Filtration
Main Filtration
Using the same adjustment as Setting the Time, Filter Cycles
are set using a start time and a duration. Each setting can be
adjusted in 15-minute increments. The panel calculates the end
time and displays it automatically.
9:15
9:16
Press “1” to view Filter 1. Press “2” once to view Filter 2. Press
“2” again to turn Filter 2 ON or OFF.
When Filter Cycle 2 is ON, it can be adjusted in the same
manner as Filter Cycle 1.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which
will shorten overall filtration by the overlap amount.
Circulation Pump Modes
Some spas may be manufactured with Circ Pump settings that
allow programming filtration cycle duration. Some circ Modes
are pre-programmed to operate 24 hours a day and are not
programmable. Refer to the spa manufacturer’s documentation
for any Circ Mode details.
Purge Cycles
In order to maintain sanitary conditions, as well as protect
against freezing, secondary water devices will purge water
from their respective plumbing by running briefly at the
beginning of each filter cycle.
(Some systems will run a certain number of purge cycles per day,
independent of the number of filter cycles per day. In this case, the
purge cycles may not coincide with the start of the filter cycle).
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter
Cycle 2 will initiate a purge when Filter Cycle 2 is programmed to
begin.
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
* For example, if your spa is set up for 24/hour circulation except
for shutting off when the water temperature is 3˚F/1.3˚C above the
set temperature, that shutoff does not occur dur-ing filter cycles.
Additional Settings
Light Cycle Option
If Light Cycle does not appear on the Settings Screen, the Light
Timer feature is not enabled by the manufacturer. The Light Cycle
Icon on the Settings Screen takes you to a screen where you
control the Light Cycle. When available, the Light Timer is
(“Disabled“) by default. Press “Disabled“ to change it to
“Enabled“ (ON). The settings can be edited the same way that
Filter Cycles are edited.
Auxiliary Panel(s)
Specific Buttons for Specific Devices
If the spa has an Auxiliary Panel(s) installed, pressing buttons on
that panel will activate the device indicated for that button. These
dedicated buttons will operate just like the Spa Screen buttons
(see page 6) and the equipment will behave in the same manner
with each button press.
Restricting Operation
The control can be restricted to prevent unwanted use or
temperature adjustments. Locking the Panel prevents the controller
from being used, but all automatic functions are still active. Locking
the Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted.
Settings Lock allows access to a reduced selection of menu items.
These include Filter Cycles, Invert, Information and Fault Log. They
can be seen, but not changed or edited.
2
9
