Coactive Aesthetics CA386-N1, Reference Manual

Page: 11 / 40

Connectors and Jumpers
Hardware
1-3
The board is designed to be powered in one of two ways:
• “Raw” power and ground connected through J7-Vin, and a regulator attached to J10 which takes the
raw power in and pr5V (and +12V, -12V if required).
• +5V (and +12V, -12V if required) supplied through J7; J10 unused.
The first method is useful for providing an internal power supply or converter in an enclosure.
1.5 Connectors and Jumpers
1.5.1 Overview
Figure 1.2 shows the locations of all the connectors and jumpers on the CA386-N1. The following sections
describe each jumper and connector in detail. Note that each connector or jumper shown below is oriented such
that the power and network connectors (J7, J9) are at the “top” of the board. Also note that the reference designa-
tors (labels) are shown in their actual location and orientation relative to the connector or jumper.