11
10
4. Using your Monitor for the First Time
Use only 1.5V “AAA” alkaline batteries with this device.
1. Press the hook on the bottom of the battery cover and lift the cover off in
the direction of the arrow.
2. Install 4 “AAA” size batteries so the + (positive) and - (negative) polarities
match the polarities of the battery compartment. Replace the battery cover.
Make sure that the battery cover is securely in position.
4.1 Activating the pre-installed batteries
Insert the cuff tube into the opening on the left side of the monitor
indicated by the drawing of a cuff.
4.3. Cuff tube connection
Battery Installation
Low Battery Indicator
1.When the Low Battery Indicator appears on the display, turn the monitor off
and remove all the batteries. Replace with 4 new batteries at the same time.
Long-life alkaline batteries are recommended.
2.To prevent the damage of monitor from leaked battery fluid, please take
out the batteries if the monitor will be unused for a long time (generally
more than 3 months). If battery fluid should get in your eyes, immediately
rinse with plenty of clean water. Contact a physician immediately.
3. Attached battery is only for testing the function of the monitor. Long-life
alkaline batteries are recommended.
4. Dispose of the device, components and optional accessories according to
applicable local regulations. Unlawful disposal may cause environmental
pollution.
5. Batteries can be dangerous. Do not mix batteries with any other trash.
Battery replacement
Configure the system settings after either after loadaing the battery or
connecting the monitor.
4.2. System Settings
A. Setting the User:
Press the SET button and then you can set the A/B user by shifting the
A/B user button.
B.Setting the Year/Month&Date/Time/Volume:
Long press the SET button for more than 3 seconds, and then you can
configure the settings.
Setting the Year:
Initial year is 2019. When the year display is flashing, press the MEM
button. The year will increase by 1 year each time. Hold the MEM button
and it will increase continuously 1 by 1, until 2049, and then rollover to
2019. Once the year SET is OK, press SET button to confirm.
Setting Month/Date:
Initial Month/Date is 1/01. When the Month display is flashing, press the
MEM Button. The month will increase by 1. Press SET button to confirm,
and do it in the same way to set the date. Press SET button to confirm.
Setting Time :
When the hour display is flashing, press the MEM button. The hour will
increase by 1. Press SET button to confirm, and do it in the same way to
set the minute. Press SET button to confirm.
Setting Volume:
When display with SP is flashing, press MEM button to switch volume 1,
volume 2, volume 3 or OFF. Press SET button to confirm.
C.Record Delete:
When you are checking the memory data, long press the MEM button
for more than 3 seconds to delete existing user measurement data.
Note:
You can’t delete all measurement records from the monitor storage at one
times. If you decide to delete all the records, please store the record in
another way, in case you need them at a later date. Taking the battery out
will not delete record.
