8
EN
G
LI
SH
A10
1
2
3
4
4.4 Cutting the lawn
1. Adjust the cutting height according to the grass height. Start with a high cutting height and adjust
accordingly for the best results.
2. Position the mower close to the power point being used and work away from the socket. Let the power
cable trail on the already cut areas.
3. Release the throttle lever and disconnect the power cable once finished.
!
Never expose the motor to overload for lengthy periods. When the mower is heavily overloaded
(high grass, etc.) the motor becomes sluggish and will make a different noise. Immediately relea-
se the
throttle
lever, disconnect the power cable and adjust the cutting height to avoid damaging
the mower.
Lengthy heavy overloads can trip the overload protection. In such cases release the
throttle
lever
and disconnect the power cable. The overload protection is reset only when the
throttle
lever is
released. Clean the mower from possible obstructions and wait a few minutes before you con-
nect the power cable and use the mower again. If the overload protection trips again, try raising
the cutting height to prevent the motor from being overloaded.
5. Maintenance
!
Always disconnect the power cable from the mower before starting maintenance or servicing.
• Clean the mower with a brush or cloth after each use.
• Never use water to wash off the mower. The electrical components can be damaged and present a risk
for electric shock.
• Tighten all nuts and screws to ensure that the mower is in good working order.
• Before using make sure to check all your electrical equipment. If there is damage to insulation, fittings or
anything else the mower must not be used.
• Always use original parts. Non-original parts can present a risk for injury even if the fit the mower.
5.1 Changing the blades (fig. A10)
1. Turn the mower on its side and inspect the blades. If the blades are blunt or damaged they should
be replaced.
2. Hold the blade (2) and loosen the bolt (1) with an adjustable spanner. Use work gloves when holding
the blades since they can be sharp.
3. Remove the blade (2) and fan assembly (3). Clean if necessary.
4. Replace the fan, new blades and bolt in reverse order according to the above. Make sure that the
blades are facing the right direction and that the bolt is securely tightened.
Summary of Contents for LM-38E
Page 2: ......
