8
English
9. Replacing/adjusting disposable cutter irons
Note: Unplug the device before service.
Remove the fence. Loosen the hexagon screws on the locking wedge (pushing the cutter iron against the cut-
ter) with the included 10 mm spanner by turning these clockwise inwards. Remove the cutter iron and the locking
wedge from the groove of the cutter. Clean the wedge, groove, and cutter iron of debris, shavings, and dust with
an oily cloth.
Turn the cutter iron or replace it. Reinstall the iron and wedge back in the groove and lock them in position by
turning the screws anticlockwise (but turn only slightly so that they do not fall out.) Check how far the cutter iron
protrudes above the output table by laying a ruler on the output table or by using a setting guage.
Maximum protrusion above the output table: 0.1 mm. Repeat with the other cutter iron.
Adjust the cutter protrusion using the included 3 mm allen key by turning the wedge`s three setscrews in and
out as desired. After achieving the correct setting, tighten the hexagon screws again. Start with the screw in the
middle.
Note: Do not use a 10 mm spanner with a shaft longer than that which is included to avoid the risk of
damaging the grooves. Immediately replace a locking wedge having with damaged grooves.
3 mm allen key
Setting guage
9.0
9.0
Summary of Contents for LBC 36
Page 39: ...39 ...
