3
English
16. Remove all keys and service tools.
Make a habit of checking that all keys and service tools are removed from the machinery before switching on
the power.
17. Avoid starting unintentionally.
Do not carry a tool with your finger on the switch/trigger if the cable is plugged into a socket. Ensure that the
switch is in the off position when connecting the plug.
18. Use the correct extension cables.
When using extension cables outdoors, only use those which are intended for outdoor use. Use extension
cables with sufficient conductivity. Uncoil the entire cable.
19. Use common sense and be careful.
Think twice before carrying out a working operation so that you can carry it out in a safe manner. Do not use
the machinery/tool when you are tired, under the influence of medication etc.
20. Before starting the machinery check:
- That all covers and other parts are undamaged and in working order.
- That all moving parts can rotate freely and are correctly set.
- That no moving parts can jam.
- That no defects have arisen.
- Other circumstances which could influence the manner in which the work is carried out.
A safety guard or other part that has been damaged must be repaired by a service technician or changed.
Damaged power cables and switches must always be changed by a qualified technician. Never use the tool if
you cannot switch it off or start it in a safe manner.
21. Use recommended fittings.
Using fittings that have not been recommended may cause accidents and personal injury.
22. Must be repaired by a qualified technician.
The machinery conforms to current safety requirements. Repairs on the machinery must always be carried
out by a qualified technician using genuine replacement parts. Otherwise the tool may cause accidents or
personal injury.
Specific safety instructions for the planer & thicknesser
•
Never use the machine unless the protective covers are undamaged, correctly installed, and adjusted.
•
Never use dull plane irons as this will increase the risk of kickback.
•
When surface planing, the unused part of the cutter must be covered by the cutter guard.
•
When surface planing short workpieces, a push stick should be used.
•
The surface plane should not be used when planing grooves, sinks, tenons, or profiles.
•
The operation of the anti-kickback mechanism and the feed rollers should be checked regularly to assure safe
operation.
•
Whether surface planing or thicknesing, a dust extractor should be attached to the plane.
Product labelling
Read the entire operations manual.
Always use protective goggles or a visor and a dust mask.
Always use ear protection.
Summary of Contents for LBC 36
Page 39: ...39 ...
