15
Reassembling the Compressor
After the connecting rod assembly and eccentric are
correctly assembled, you can assemble the valve plates and
bead to the compressor.
O-ring Groove
Bottom of Valve Plate
Power Leads
1
、
Insert the valve plate gasket O-ring into the O-ring
groove located on the bottom of the valve plate.
2
、
Position the compressor housing as shown in the
illustration. Notice the orientation of the power leads.
Note: Make sure that the connecting rod sleeves
are seated against the compressor housing.
3
、
Observe the orientation of the valve plate
assemblies. Place them on the compressor
housing as shown.
Tab
Tab
Compressor Housing
Valve Plate
4
、
Inset two new head gasket O-ring into the
groove located on the bottom of the Head.
Note: Ensure the valve plate is properly
engaged to housing locators.
Note: Ensure that O-Rings are fully
assembled in grooves and not pinched.
Botto m of the Head
O-ring Gasket
Caution
:
To
prevent
damage
to
the
compressor,
never
apply
any
sealant
or
lubrication
to
the
O-rings.
！
