Operating Instructions
Zero-4 / 5-Channel Stepper Controller
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 12
Support: +49 (0)2831/91021-50
6/16/2021
3 .5 . 3
Hydraulics, pneumatics, steam
•
Work on hydraulic equipment may only be carried out by people with
special knowledge and experience in hydraulics!
•
Check all cables, hoses, and screws regularly for leaks and externally
recognizable damage! Eliminate damage immediately! Oil spraying out
can lead to injuries and fires.
•
Open system sections and pressure lines to (hydraulics, compressed air,
coolants) make them pressure less before the start of the repair work
according to the assembly descriptions!
•
Lay and assemble hydraulic, coolant and compressed air lines
professionally! Do not swap the connections! Fittings, as well as length
and quality of the hose lines must meet the technical requirements.
3 .5 . 4
Oils, fats, gases, and other chemical substances
•
When handling oils, fats, gases, and other chemical substances, observe
the safety regulations applicable to the product!
•
Be careful when handling hot operating and auxiliary substances (risk of
combustion or scalding)!
3 .6
S a fe t y
•
Emergency stop device with emergency stop buttons on control housing. (Emergency stop
chain according to valid regulation)
