Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 325 / 414

GASOLINE VEHICLE - ENGINE Oil Level Sensor
20
6. Pull oil level sensor (5) out of engine.
OIL LEVEL SENSOR INSTALLATION
1. Lubricate oil level sensor o-ring with oil and carefully insert sensor (5) into engine until fully seated.
2. Secure sensor (5) to engine with two bolts (4) and tighten to 80 in·lb (9 N·m) (Figure 20-11, Page 20-13) .
3. Connect oil level sensor wire (3) to wire harness.
4. Secure oil sensor wire (3) with clamp (2) and bolt (1). Tighten bolt to 80 in·lb (9 N·m).
5. Install flywheel and fan shroud. See Ignition Coil Removal on page 20-14.
6. Fill engine to proper level with correct type of oil. See Engine Oil – Gasoline Vehicle, Section 20, Page 20-2.
5
4
3
2
1
3038
Figure 20-11 Oil Level Sensor – EX40
2019 Precedent Villager 2 Maintenance and Service Manual Page 20-13