Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 326 / 414

20
Ignition Coil GASOLINE VEHICLE - ENGINE
IGNITION COIL
See General Warnings on page 1-2.
TESTING THE IGNITION COIL
See Test Procedure 14 – Ignition Spark on page 18-28 and Test Procedure 15 – Ignition Coil on page 18-29.
IGNITION COIL REMOVAL
1. Remove screws (1) and fan housing (2) (Figure 20-8, Page 20-11) .
2. Disconnect ignition coil primary lead wire (12) from spade terminal (13) on ignition coil (11) (Figure 20-12,
Page 20-14) .
3. Remove two bolts (10) and pull ignition coil (11) from engine.
12
11
13
10
0.012 Inch
(0.304 mm)
6
510
Figure 20-12 Ignition Coil
512
Figure 20-13 Adjust Ignition Coil Air Gap
IGNITION COIL INSTALLATION
1. Position ignition coil (11) onto engine and tighten two mounting bolts (10) finger-tight at this time (Figure 20-12,
Page 20-14) .
2. Rotate flywheel until its magnet is positioned directly under ignition coil (11). Use a bronze feeler gauge to set air
gap between ignition coil and flywheel magnet from 0.012 to 0.020 in. (0.3 to 0.5 mm)
(Figure 20-13, Page 20-14) .
3. Tighten ignition coil bolts (6) to 71 in·lb (8 N·m).
4. Connect ignition coil primary lead wire (12) to terminal (13) on coil (Figure 20-12, Page 20-14) .
Page 20-14 2019 Precedent Villager 2 Maintenance and Service Manual